Fanuc FOCAS

Enable Fanuc FOCAS monitor

Check this field to enable the Fanuc FOCAS monitoring.

Host/Addr:

Use this field to specify the CNC host name or IP address.

Ping before connecting

Check this field to limit the TCP/IP connection load by pinging the device before attempting to open the COM port.

If the device does not respond to a ping message no attempt is made to open the port.

Log message when port starts

Check this field to generate a message when the port starts.

CNC Type

Log message when port starts

Check this field to generate a message when the port starts.

Cycle On

Use this field to specify the message generated when the cycle is on.

Cycle Off

Use this field to specify the message generated when the cycle is off.

Alarm On;

Use this field to specify the message generated when the control goes into alarm.

Alarm Off

Use this field to specify the message generated when alarm stops.

Feed hold On

Use this field to specify the message generated when feed hold on.

Feed hold includes single step etc.

Feed hold Off

Use this field to specify the message generated when feed hold is off.

Feed hold includes single step etc.

Program changed

Use this field to specify the message generated when program changed.

M30 Counter #1

Use this field to specify the message generated when M30 Counter #1 changes

M30 Counter #2

Use this field to specify the message generated when M30 Counter #2 changes

Enable control modes

Check this field to enable control modes.

Panel Option

Enable Macro 1

Macro

Check for change

Val.1

Message val.1

Val.2

Message val.2

PMC Variables

PMC Address

Bit

Data Type

On

Off

Notify change of Work Zero Offset

Message