• CIMCO CNC-Calc v6 Dokumentation
    • CIMCO CNC-Calc v6 Benutzerhandbuch
      • Überblick
      • Installation
      • Mausfunktionen
      • Werkzeugleisten
        • Datei
        • Ansicht
        • Elemente bearbeiten
        • Fangen
        • Punkte / Linien zeichnen
        • Kreise / Kreisbögen zeichnen
        • Bohrbild
        • Text
        • Fräsen Operationen
        • Drehen Operationen
      • Menüs
      • CNC-Calc konfigurieren
        • Einstellungen
        • Farbeinstellungen
        • Andere Einstellungen, die CNC-Calc betreffen
    • CNC-Calc Tutorials
      • Tutorial Mill 1 - 2D Construction of a Part for Milling
        • Open a New Drawing
        • Draw the Geometry
          • Draw a rectangle with round corners
          • Draw a circle defined by its center and radius
          • Draw vertical and horizontal lines
          • Offset a circle
          • Create a fillet between elements
          • Mirror elements
          • Connect the inner elements
        • Save the File
      • Tutorial Mill 2 - Machining the Part
        • Planfräsen
          • Inserting a Tool with Feed and Speed Calculator
        • Kontur Fräsen
          • Inserting a Tool with Feed and Speed Calculator
        • Taschenfräsen
        • Drilling
      • Tutorial Mill 3 - Backplot in the Editor
        • The First Backplot
        • Backplot Tool Setup
        • Backplot Stock Setup
      • Tutorial Mill 4 - Milling of Letters
        • Simple Letters Milling
          • Drawing the Text
          • Milling of Letters
        • TrueType Letters Milling
          • Drawing the Text
          • Contour Milling of Letters
          • Pocket Milling of Letters
      • Tutorial Lathe 1 - 2D Construction of a Part for Turning
        • Open a New Drawing
        • Draw the Geometry
          • Draw vertical lines defined by start point and length
          • Offset an element
          • Draw a circle defined by its center and radius
          • Draw a line defined by its endpoints
          • Draw a horizontal line defined by its length
          • Draw a polar line
          • Chamfer the foremost corner
          • Draw a line defined by its endpoints
          • Trim between points of intersection
          • Fillet intersections
        • Save the File
      • Tutorial Lathe 2 - Machining the Part
        • Facing the Front of the Stock
        • Roughing the Part
        • Grooving the Part
        • Finishing the Part
        • Threading the Part
          • Select Thread
        • Drilling the Part
        • Tapping the Part
        • Parting-off the Part
Updated on October 12, 2017 at 11:28
Copyright © CIMCO A/S | CIMCO Americas, LLC. All rights reserved.